Beyerdynamic MCS 50 Notice D'utilisation page 43

6.5 Microphone Data - Selection of Chairman Microphone Units
6.6 Saving
6.7 Downloading the Data
Note
If the connection is not set up, check the interface configuration in the MCS-Editor. Choose the "Diverse" menu item and the "Configuration"
command to define the free serial interface (set to "COM 2" at the factory).
6.8 Status Check
Choosing the "Control" menu and the "Status Check" command all possible 32 microphone units are checked. All
microphone units that were found appear on the screen. The computer differentiates the microphone units by
types.
Type 1 = Microphone unit without loudspeaker
Type 2 = Microphone unit with loudspeaker
Note
If the PC does not indicate a microphone unit, check the addressing and the cable connection of that microphone unit.
After the status check the chairman microphone unit can be selected. This is achieved by marking
the corresponding microphone unit and the "Chairman" panel. A delegate microphone unit can
be selected also as chairman. (Refer to chapter "1.2 Microphone units" and "1.3 Addressing of
the microphone unit".)
Important: It is only possible to select the number of microphone units as chairman that have
been entered in the "Max. Chairman" panel before. In the "Mute Stations" panel you can
select the microphone units of which the loudspeakers have to be muted (e.g. neighbouring
microphone unit). This function should be used, if the microphone units stand too close to each
other and feedback sets in too early.
When you have entered all data, access the "File" menu and the "Save" command.
Enter a name for the file and click "OK". You should also save when you have changed
something.
For downloading the entered data to the MCS 50 discussion control unit access the "Control"
menu and the "Download" command. The data are downloaded to the MCS 50 discussion
control unit. After this the MCS 50 is starting a new system check and if the system is "OK", the
default screen will appear.
43