Synchronous Recording - Teac CD-RW880 Manuel Du Propriétaire

Synchronous recording means that recording will begin
automatically when a signal is received, and will stop when the
signal ends.
The conditions under which an input signal is used as the
trigger to start recording are:
when recording a CD digitally, a digital start signal is
detected, and audio is also detected
when recording an MD or DAT digitally, a digital start signal is
detected
the sound level has dropped below the increment level for
one second or more, and has then risen above the increment
level again
The conditions under which synchronized recording stops
are:
when recording digitally, a digital stop signal is detected
the sound level drops below the increment level for 5 seconds
To start synchronous recording
1 3
After step of page 16, press the SYNC 1/ALL button
and select SYNC 1 or SYNC ALL.
When the SYNC 1/ALL button is pressed once, the current
setting is displayed. Press the SYNC 1/ALL button repeatedly
to select any other setting.
SYNC ALL
Select this to record all the tracks.
SYNC 1
Select this to record only one track.
SYNC OFF
Select this when you don't use this function.
The SYNC indicator lights when SYNC ALL or SYNC 1 is
selected.

Synchronous Recording

or
or
or
2 Press the RECORD button.
The unit enters record pause mode.
< The PLAY or the PAUSE button doesn't work in synchronous
record pause mode.
3 Start playing the source.
The unit will start synchronous recording.
< During digital synchronous recording, if the input signal stops
for 5 seconds, recording will stop automatically.
< Press the STOP button to stop the recording manually.
< If you press the STOP button or the PAUSE button during
recording, the synchronous recording function will be
cancelled.
< The synchronous recording function automatically turns off
after the recording.
< The SYNC 1/ALL button doesn't work during recording or in
the record pause mode.
< When SYNC ALL is selected, AUTO TRACK is always on.
Select –60, 50, 40 or 30 dB using the AUTO/MANUAL button.
< If the AUTO/MANUAL button is set to MANUAL, AUTO
TRACK (–60 dB) will be selected during synchronous
recording. The setting automatically returns to MANUAL after
the recording.
19