Listening To A Cd - Teac CD-RW880 Manuel Du Propriétaire

1
1
Press the POWER switch.
The unit enters standby mode, and "STAND-BY" lights on the
display.
2 Press the STANDBY/ON button of the remote control
unit to turn the unit on.
When no disc is set, "NO DISC" appears on the display.
< If one of the following buttons is pressed in the standby
mode, the unit will also turn on:
OPEN/CLOSE, PLAY, STOP
3 Press the OPEN/CLOSE button (L).
4
Place a disc on the tray with the printed label face up.
< Never place more than one disc on the tray.
< The disc must be placed in the center of the disc tray. If the
disc is not correctly loaded, it may not be possible to open the
tray again once it has closed, so you should ensure the disc is
always centered on the tray.
< Do not force the tray by hand during opening and closing
operations.
10

Listening to a CD

4 3 6
5
5 Press the OPEN/CLOSE button (L) to close the tray.
< It takes a few seconds for the unit to load the disc. No
buttons will work during loading. Wait until the total number
of the tracks and the total play time of the disc are displayed.
total number of the tracks
< The disc type indicator shows the type of disc currently
loaded.
CD:
A commercial pre-recorded CD
CD-R:
A finalized CD-R
CD-RW:
A finalized CD-RW
CD-R NO TOC :
A CD-R which has yet to be finalized
CD-RW :
NO TOC
A CD-RW which has yet to be finalized
blank:
No disc
6 Press the PLAY button (y) to start playback.
Disc playback starts from the first track, and the PLAY
indicator (y) lights on the display.
< If you load the disc, and then press the PLAY button without
having first closed the disc tray, the disc tray closes and
playback starts.
disc type indicator
total play time of the disc