Before Recording; Serial Copy Management System - Teac CD-RW880 Manuel Du Propriétaire

To check the programmed order
In the stop mode, press the PROGRAM CHECK button
repeatedly to show the track numbers that have been stored
in memory.
To add a track to the end of the program
In the stop mode, press the PROGRAM button, and select a
track number using the numeric buttons. The track is added
to the end of the program.
To overwrite the program
In the stop mode, press the PROGRAM CHECK button
repeatedly until the program number to be changed appears
on the display.
Press the PROGRAM button, and select new track number by
pressing the numeric buttons to overwrite the program.
To delete a track from the program
In the stop mode, press the PROGRAM CHECK button
repeatedly until the program number to be deleted appears
on the display, then press the CLEAR button. The selected
track is deleted from the program.
To clear the program
In the stop mode, hold down the CLEAR button for more
than 2 seconds.
If the OPEN/CLOSE button or the POWER button is pressed,
the programmed contents will also be cleared.

Before Recording

Before you start recording, make sure that you understand
the following points:
< The unit requires Digital Audio CD-R or CD-RW media for
recording. Computer CD-R or CD-RW discs do not work with
this unit.
< Once you have recorded on a CD-R disc, the data cannot be
erased from it.
< You can add tracks to an unfinalized recordable disc. Once
finalized, a CD-R disc is "fixed" and behaves in the same way
as a CD. Finalized CD-RW discs, however, can be unfinalized,
erased and re-recorded.
< Due to the system restrictions of CD, a track cannot be less
than four seconds in length, and there can be a maximum of
99 tracks on an audio CD.
< If the STOP button or PAUSE button is pressed within four
seconds from the beginning of a track, the unit continues to
record no signal and stops when the track's length reaches
four seconds.
< When the recording is finished, "PMA WRITE" blinks for a
few seconds, and the unit then goes into stop mode. Do not
apply shock or vibration to the unit during recording.
< If the disc reaches the end during recording, the unit will start
a fade-out over a few seconds and stop recording.
< If the disc reaches the end of the 99th track during recording,
the unit stops.
< The recording time of a track may differ slightly from the
original one.

Serial Copy Management System

This unit is in compliance with the Serial Copy Management
System standard. This standard has been established to
restrict digital-to-digital copying to only the first generation.
The basic rules governing this system are as follows:
Rule 1
A digital recording is possible from a digital source such as a
CD, DAT or MD onto a recordable CD-R, CD-RW, MD or DAT
through a digital input connection. However, further digital
to- digital recording is prohibited for the second and later
generations.
Rule 2
When an analog source such as an analog disc or FM
broadcast is digitally recorded by using a CD-R, CD-RW, MD
or DAT, this recorded source can be digitally recorded on
another CD-R, CD-RW, MD or DAT. However, further digital
copying is prohibited.
15