Flush-Fitting - Panasonic KY-T935XL Mode D'emploi

Flush-fitting

This appliance can be fitted flush when installing.
Installing the appliance as flush-fitting
■ Only suitable for installation on heat and water resistant worktops such as
marble, natural stone, solid wood (if cut out edges are sealed).
■ Mount onto other types of worktops only with the recommendation of the worktop
manufacturer.
■ Remove the cushion from the underside of the appliance before flush fitting.
■ The internal width of the base unit must be at least as wide as the internal
cut-out width for the hob. This is to ensure that the casing can be easily removed
for maintenance.
■ Before sealing in, test that the appliance works. Grout the perimeter using a heat
resistant silicone. Smooth the seal with a suitable finishing product.
Follow the silicone instructions and do not turn on the appliance until the silicone
is completely dry.
CAUTION
■ Please observe the diagrams for the cut-out dimensions in granite
■ Using unsuitable silicone may cause permanent colour changes to
Uninstalling the appliance as flush-fitting
■ Disconnect the appliance from the mains.
■ Remove the silicone seal from the perimeter with a suitable tool.
■ Push the appliance upwards from below to remove it.
CAUTION
Do not try to remove the appliance by prying it out from above.
48
EN-
490
524
29
and marble worktops.
marble worktops.
R3
R3
870
904
(measurement: mm)
17
5.5