SystemAir ROOFT@IR RT30 Manuel D'installation Et De Maintenance page 20

RT30 - RT40 - RT50
The electric connection of range RT is done in a single point on the level of the principal circuit breaker (copper
wire cable recommended).
These units are equipped with a local switch used as general terminal board.
3N~400V
Use a pozidrive M3.5 screwdriver, Form Z, to make the connections.
Use a key for hexagonal socket screws of 4mm, to make the connections.
RT60 - RT70 - RT80
The switch can be padlocked.
A circuit breaker or fuse holder ( not supplied ) must be installed on the main power
supply of the unit in accordance with the circuit diagram; for the raitings, refer to the
electrical specifications.
RT100 - RT110
18