Steba IK 55 Mode D'emploi page 18

Troubleshooting
Dear Client,
Thank you for buying this STEBA product. The following table will help you with pro-
blems that may occur when using your device. For many problems there is a simple
solution, because not everything that appears like a malfunction must be serious.
Please check the following list before contacting our customer service.
Problem
No light after
plug-in of the
device
A signal tone
sounds and no
heat occurs
Plate does not
heat anymore
Error code „E0"
Error code „E1"
Error code „E2"
Error code „E3"
Error code "E4"
Error code "E5"
Error code "E6"
Error code "E7"
18
Reason
∙ No power
∙ To many devices at one
power cord
∙ Pot not suitable for induc-
tion
∙ Pot is empty?
∙ Temperature too high?
∙ Ventilation slot blocked?
∙ Cooking time above 2 hours
without timer?
∙ Error in the circuit
∙ Pot not suitable for induc-
tion
∙ Overheat of the device
∙ Over-voltage
∙ Under-voltage
∙ Short circuit cooking plate
∙ Short circuit electronic
∙ Top plate overheat
Solution
∙ Check is plug is plugged-in
correctly
∙ Check the fuse
∙ Use suitable cookware
∙ Refill pot
∙ Lower temperature
∙ Clean ventilation slots
∙ Use timer, reset tempera-
ture/power mode
∙ Contact service
∙ Use suitable cookware
∙ Take the pot from the
device and let it cool down,
then restart
∙ Contact service
∙ Contact service
∙ Contact service
∙ Contact service
∙ Let the device cool down,
then restart