Babyauto Winy Savile V3 Notice D'instruction page 28

6. ADJUST THE HARNESS TO THE HEIGHT OF THE CHILD.
WARNING
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (6.1).
Changing the harness height
1. Adjust the height of the harness, by pressing the harness
adjustment button and pulling the harness straps towards you to
loosen them (6.2).
2. Then unhook one of the harness connector straps
harness straps pad connector
the loose strap towards the front of the seat (6.3, 6.4).
3. Insert the harness strap into the
at the front of the seat. Then insert the harness strap into the
appropriate upper or lower slot at the rear of the seat (6.5).
4. Reinsert the harness strap in the harness connector
of the seat, then reinsert the harness strap pad in the harness
connector
5. Then, do the same with the other harness strap. Verify that the 2
harness straps go through the slots at the same height.
Fastening the harness
1. Join the 2 buckle metal connectors (6.8).
2. Pass both connectors through the slot in the upper part of the
buckle until you hear a "click" (6.9).
3. Always make sure the harness is properly fastened by pulling the
harness straps upwards.
4. To unfasten the harness press the red button on the buckle
downwards (6.10).
Tightening the harness
1. Pull the harness straps up to remove the slack from the lap section
of the harness, then pull the harness regulating strap
harness is fully stretched (6.11).
2.The harness should be as tight as possible without causing
discomfort to your child.
28 Child restraint system
O connector Q (6.6).
O at the back of the seat and pull
L slot of the fabric and backrest
S and the
S on the back
K until the
SAVILE V3E