Babyauto Winy Savile V3 Notice D'instruction page 26

3. Install the child seat rearward facing, making sure it is firmly pressed
against the vehicle seat backrest (3.3).
4. Slide over the vehicle´s diagonal belt from the
rear upper seat and the abdominal belt by the guides I, under the
car seat making sure to pass it on the inside base
that it remains fastened by this (3.4, 3.5 y 3.6)
5. Fasten the seat belt into the vehicle´s buckle until it "clicks", making
sure the child seat is properly installed ( (3.7).
Ensure that the belt has no slack.
4. INSTALLING CHILD SEAT. GROUP 1.
WARNING
Always check that the harness straps are suitable for the height of
your child. The shoulders of the child should always be just below the
back slots at a suitable height (6.1).
1. From the base of the car seat, please change the
the base to the rear position by turning it on its axis (3.1).
2. The seat must be in its most upright position to adjust reclining
angle of the child seat, pull the control red handle
until the desired position is achieved (4.2).
3. Fit this child seat into the vehicle´s seat, making sure it is firmly
pressed against the vehicle seat backrest (4.3).
4. Pass the seat belt through both
4.6).
5. Insert the vehicle safety belt in the vehicle anchor point. You will
hear a "click" when properly installed. (4.7).
6. Tighten the lap belt and diagonal shoulder belt, then place the red
safety clip
vehicle anchor point as possible without touching it! (4.8, 4.9 y
4.10).
26 Child restraint system
T on the diagonal shoulder belt tongue as near to the
Only suitable for group 1, approx.
9 months to 4 years of age (9-18 Kg.)
N guides behind the seat (4.4, 4.5 y
M guideway from the
R controller, so
R controller from
L towards you
SAVILE V3E