Temperature Measuring - VOLTCRAFT VC880 Notice D'emploi

i) Temperature Measuring
During temperature measurement, only the temperature sensor must be subject to the the temper-
ature to be measured. The meter working temperature must not be undercut or exceeded. Other-
wise, there may be measuring errors.
The contact temperature sensor must only be used at voltage-free surfaces.
Any K-type thermo sensor may be used for measuring
temperatures. The temperature can be displayed in °C or °F. Optional
sensors can be used for the complete measuring range (-40 to +1000 °C).
For measuring temperatures, proceed as follows:
- Switch on the DMM and select measuring range "°C". Press the
"SHIFT/SETUP" button to switch the measurement function to dis-
play in °F. Pressing this button again takes you to the first measur-
ing function, etc.
- Plug the optional thermo sensor into the V measuring jack (7) in the
right polarity with the plus pole and into the COM measuring jack
(8) with the minus pole. If necessary, use suitable K type plug-in
adapters.
- The main display indicates the temperature value in °C or °F
according to the setting via the "SHIFT/SETUP" button.
- When "OL" is displayed the measuring range has been exceeded.
- After measuring, remove the sensor and turn off the DMM.
When the measuring input is bridged (sockets: °C – COM) the DMM device temperature is indicated. Due to the
closed casing, the temperature is only slowly adapted to the ambience temperature.
49