Controls Elements - VOLTCRAFT VC880 Notice D'emploi

Any use other than that described above damages the product. Moreover, this is linked to dangers such as short cir-
cuits, fire, electric shock, etc. No part of the product must be modified or rebuilt!
Read the operating instructions carefully and keep them for later reference.
Always observe the safety instructions!

3. Controls Elements

See fold-out page
1 Rubber protection frame
2 Display
3 SHIFT/SETUP button for function switching (red symbols)
4 Rotary Control for selecting the measuring function
5 mAµA measuring jack
6 10 A measuring jack
7 °CHzVΩ measuring jack (with commensurability "Plus")
8 COM measuring jack (reference potential, "Minus")
9 Low Imp. 400 kΩ button for switching impedance
10 Function buttons:
RANGE: Manual measurement range switching
REL/PC: REL = Reference value measurement, PC = Activates interface
MAX/MIN: For recording and displaying the max and min values
H/LIGHT: Hold function for holding the measuring display, adding the display lighting
11 Optically isolated interface
12 Stand connection thread
13 Foldable standing bracket
14 Battery compartment
15 Screw for battery and fuse compartment
16 Fuse compartment
Probe assemblies to be used for MAINS measurements shall be RATED as appropriate for MEASU-
REMENT CATEGORY III or IV according to IEC/EN 61010-031 and shall have a voltage RATING of at
least the voltage of the circuit to be measured.
38