Measuring The Temperature - VOLTCRAFT CA VC-740E Mode D'emploi

l) Measuring the temperature
When taking a temperature measurement, only allow the temperature probe to come into contact
with the surface of the measured object. The multimeter must not be exposed to temperatures
below or in excess of the operating temperature, as this may lead to incorrect measurements.
The temperature probe must only be used on voltage-free surfaces.
The multimeter features a wire sensor that can measure temperatures from -40
to + 250 °C. To use the full temperature range (-40 bis +1000 °C), purchase a
Type-K thermal sensor. An adapter plug is required to connect Type-K sensors
with a miniature connector.
All K-type thermal sensors can be used for taking temperature measurements.
The temperature can be displayed in °C or °F.
Proceed as follows:
- Turn the multimeter on and select "°C °F" mode. The temperature unit (°C) will
appear on the display.
- Insert the Type-K wire sensor into the
polarity.
- When using a thermal sensor with miniature connectors, connect the sensor
to a compatible adapter. The two contacts on the thermal sensor plug have a
different width to ensure that they are connected correctly.
- The display shows the temperature in °C.
- Press "SELECT" to switch the unit from °C to °F.
- "OL" indicates that the measurement range was exceeded or the sensor was
disconnected.
- After measuring, remove the sensor and turn off the multimeter.
and COM sockets in the correct
51