Controls Elements - VOLTCRAFT VC930 Notice D'emploi

If you have reason to believe that the device can no longer be operated safely, disconnect it immediately and make
sure it is not unintentionally operated. It can be assumed that safe operation is no longer possible if:
- the device shows any visible damage,
- the device no longer works and
- the device was stored under unfavourable conditions for an extended period of time or
- after it was exposed to extraordinary stress caused by transport.
Do not switch the meter on immediately after it was taken from a cold to a warm environment. The condensation that
forms might destroy your device.
Allow the device to reach room temperature before switching it on.
Do not leave the packaging material lying around carelessly since such materials can become dangerous toys in the
hands of children.
Also observe the safety information in each chapter of these instructions.
4. CONTROL ELEMENTS
See fold-out page
1 Rubber protection frame
2 Display
3 Function buttons:
RANGE: Manual measurement range switching
: Button for function switching
HFR: High Frequency Reject, button for low-pass filter activation
DIGIT: Button for switching the display
: Control cross for submenu navigation
ENTER: Confirmation button
CANCEL: Button for canceling or terminating a function
A-HOLD: Button for activation of the auto HOLD function
P-HOLD: Button for activation of the peak HOLD function
4 Rotary control for selecting the measuring function
5 mA measuring jack
6 10 A measuring jack
7 Hz°CVΩ measuring jack (at equal values "Plus")
8 COM measuring jack (reference potential, "Minus")
9 Photo sensor for automatic backlighting
10 Optically isolated interface for data transfer
11 Measuring line holder
12 Foldable standing bracket
13 Battery compartment
3