Bronpi ALHAMBRA Instructions D'installation, D'utilisation Et D'entretien page 19

Double combustion
Some models of the stoves include a double combustion. With this system we
get a second preheated entry air inside the combustion chamber. This allows a
second combustion of the not burnt gases in the first combustion that achieves
a high performance efficiency, a great fuel saving and reductions in pollutant
emissions.
- The models Sydney, Petra, Preston, Derby and Bury have this air intake
control for the double combustion under the door, which is the same
than the secondary air intake control. This control is placed on the
right and the movement is from inside to outside and vice versa. The
operation to outside increase the air input (see drawing D8).
into the combustion chamber, thanks to itineraries designed by Bronpi. This combustion process designed by Bronpi makes the most of the
calorific power of the wood, while reduces the most harmful emissions as well as the consumption of wood.
Baffle plate
The baffle plate is a fundamental part for the proper operation of the stove. It must be placed in the right position and the stove must not be
used without the baffle plate. This would invalidate the warranty.
The combustion is not always stable. In fact, it can be affected by the weather conditions or the outside temperature. This modifies the draw
of the chimney. For this reason, our stoves have a baffle plate (or double baffle plate)
WARNING!
The lack of the baffle plate causes an excessive draw. This causes a fast combustion, excessive wood consumption and
the overheating of the equipment.
Due to safety reasons during the transport, the baffle plate is not assembled. You will find it inside the combustion chamber. To place it
properly, follow the next steps:
Frontal models:
D10
In models Petra, Sydney and Dover the baffle plate must be rested on the side supports of the combustion chamber and you have to fit on
the groove where the air of the double combustion goes off (see drawing D12).
NOTE: some models with oven does not have a baffle plate.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS
D9
- There are many others models such as Irlanda, Ávila, Tudela, Vitoria,
Alhambra, Sena, Soria, Oxford, Etna, Ordesa, Bremen, Preston, Derby and
Bury whose entry of preheated air exists but it is not adjustable. The air
supply is usually made by little drillings on the back wall of the combustion
chamber (see drawing D9).
Triple combustion
In the model Dover, the regulation is located under the door to the right,
both the double and triple combustion. With this regulation open (regulation
completely extracted, outside), it is possible to introduce hot oxygen twice
D11
18
D7
D8
Corner models :
STOVES