Accessories - IKAR HWB 1,8 Mode D'emploi

3. The required clearance below the edge is shown in Figures
4. In order to prevent a fall with a swinging movement the working area and the lateral movement from the
centre line have to be limited to max. 1.50m on both sides. In other cases, no single anchor points shall be
used, but e.g. type C / class C anchor devices (only if approved for shared use) or type D / class D devices
according to EN 795.
5. For use of the fall arrester on a type C / class C anchor device according to EN 795 with a horizontally fl exible
anchor line the excursion of the anchor device must also be considered when determining the required
clearance underneath the person using the device. The information provided in the instructions for use and
the safety information of the anchor devices have to be observed in this context.
6. In case of a fall over an edge there is a danger of injury during the process of arresting the fall due to the
falling person hitting parts of the building or structure.
7. Special measures for rescue has to be defi ned and trained for cases of falls over an edge.
8. Fall arresters labelled with Figure
retractable lanyards made of Dyneema or stainless steel cables).
9. For the correct distance from the device to the edge in case of horizontal use see the list at the beginning of
these instructions for use (
Please note: In order to prevent a negative impact on the safe function of the fall arresting devices, it is only permit-
ted to use accessories approved by the manufacturer (e.g. rescue clamps to DIN 19428:2018, protective covers,
etc.). The manufacturer is not liable for any accidents involving the life and limb of the user if using non-approved

accessories.

15
Fall over edges at right angle
Safe distance
(minimum)
ENGLISH
are unsuitable for an impact load over unprotected edges (e.g.
14
)
18
Accessories
3.00m
+ 1.00m
4.00m
+ + .
15 16 17
16 Fall over edges with lateral offset
Safe distance
(minimum)
15
13
14
17
18
3.00m
+ 1.00m
4.00m