Safety Recommendations - Krups FNC2 Mode D'emploi

English
Description
a Lid
b Removable water tank
c Visible water level
d Warming plate for cups
e Steam / coffee selector
f Operational indicator light (red)
g Temperature control light (orange)
h Start / stop switch
i Brewing head
j Steam nozzle
k accessory
l Grid
m Drip plate
n Measuring spoon
o Filter for one or two cups
p Filter holder for ground coffee
q ESE filter holder and filter system

Safety recommendations

Please read these instructions carefully
•
before first using your espresso. The
appliance must only be connected to the
mains via an earthed plug. Check that the
voltage shown on the appliance's indicator
plate corresponds to that of your electricity
system.
Wiring instructions for U.K and Ireland
only :
APPLIANCES WITH FITTED PLUG
Important : For your convenience this
appliance is supplied complete with a plug
incorporating a 13 amp fuse.
In the event of replacing a fuse in the plug
supplied, a 13 amp fuse approved by ASTA to
BS1362 must be used.
If the socket outlets are not of the 13A BS
1363 type, and therefore do not accept the
plug connected to this appliance, cut off the
plug.
When cut off, this plug is a shock hazard if
inserted into a socket outlet and must
therefore be disposed of safely.
16
If the fuse cover is detachable, never use the
plug with the cover omitted. Replacement
covers can be obtained from your service
agent.
Fit the appropriate plug according to the
instructions in paragraph "Fitting a plug".
With alternative plugs a 15 amp fuse must be
fitted either in the plug or adaptor or at the
main fuse box.
APPLIANCES WITHOUT FITTED PLUG
FITTING A PLUG - IMPORTANT
The wires in the mains lead are coloured in
accordance with the following code:
GREEN & YELLOW
BLUE
BROWN
As the colours in the mains lead of this
appliance may not correspond with the
coloured markings identifying the terminals in
your plug, proceed as follows:
The wire which is coloured GREEN & YELLOW
must be connected to the terminal in the plug
which is marked with the letter 'E' or by the
earth symbol or coloured green or green
and yellow. The wire which is coloured BLUE
must be connected to the terminal which is
marked with the letter 'N' or coloured black.
The wire which is coloured BROWN must be
connected to the terminal which is marked
with the letter 'L' or coloured red.
This appliance is manufactured to conform to
the Low Voltage Electrical Equipment (Safety)
Regulations 1989 and is designed to comply
with BS 3456. It complies with the
requirements of the EEC Directive (89/336/
EEC).
• Never put your espresso on a hot surface
(electric warming plate, for example) or close
to a flame.
Never remove the filter holder containing
•
the coffee grounds while water is being
passed through, since the appliance is under
pressure at this time.
Never use the appliance if the drip plate and
•
the grid are not in position.
Disconnect the electricity if there is any
•
problem while the coffee is percolating or
prior to cleaning your appliance.
: EARTH
: NEUTRAL
: LIVE