Maintenance; Light Bulb Replacement; Important - Maytag RJRS4270A Guide De L'utilisateur

M A I N T E N A N C E
C
ONDENSER
Cleaning of the condenser is recom-
mended every 3-6 months.
TO CLEAN:
• Remove Machine Compartment cover
(see page 4).
• Turn the power to the unit off using the
Main Power switch.
NOTE:
Turning the power off on the elec-
tronic control panel inside the refriger-
ator stops cooling only in both com-
partments. It DOES NOT turn off
power to the unit.
• Use the soft
brush vacuum
attachment
to loosen dust
and lint on
the condenser fins. Vacuum to remove
the soil.
• After cleaning, turn the Main Power
switch back on.
• Replace the machine compartment
cover.
L B
IGHT ULB
R
EPLACEMENT
U F F
PPER RESH OOD AND
F C
REEZER OMPARTMENTS
There are light bulbs at the top of each
compartment.
WARNING:
member to turn OFF ("O") the
power to the refrigerator at the
main power switch and to wear
gloves when replacing light bulbs.
TO ACCESS THE UPPER LIGHT
BULB AREA IN EITHER
COMPARTMENT:
• Push in on
the finger-
tabs located
behind the
electronic control panel at the top of
the compartment.
• Lower the light shield.
• Replace the burned out bulb(s) with
standard A15-40 watt appliance bulb(s).
Available from your dealer.
• After replacing
the bulb(s), push
the light shield
up into its orig-
inal position.
L
OWER
C
OMPARTMENT
There is a T8-40 watt bulb located behind
each OptiFresh™ drawer. Replacement
bulbs are available from your dealer.

IMPORTANT:

• To avoid damage to the OptiFresh™
drawers, power must be turned off
at the Main Power switch (see page 4)
before changing the bulb.
TO REPLACE THE BULB BEHIND
THE UPPER OPTIFRESH™
DRAWER:
• Turn the power off to the refrigerator
at the Main Power switch in the upper
machine compartment (see page 4).
• Unload and remove the upper
Always re-
OptiFresh™ drawer.
F F
RESH OOD
19
• Remove the OptiFresh™ air diverter
located at the rear of the fresh food
compartment.
• Lift up and remove the glass shelf.
Air Diverter
Strip
Shelf
• After the shelf is
removed, 2 mounting
screws are visible
behind the drawer.
Using a 1 " hex head
⁄
4
screw driver, remove
these screws.
• Slide the compartment assembly forward.
• Unscrew the bulb and replace with a
new T8-40 watt bulb.
• Slide the assembly back into its original
position. Align the screw holes, making
sure air ducts are in alignment. Replace
the two screws. Replace the shelf and
the air diverter strip. Reinsert the
drawer into the compartment.
• Turn the power to the refrigerator back
on.
IMPORTANT:
• Do not remove the foam piece
between the OptiFresh™ drawers.