Professional Temperature Management System; Power Switch; Door Alarm - Maytag RJRS4270A Guide De L'utilisateur

P R O F E S S I O N A L T E M P E R A T U R E
M A N A G E M E N T S Y S T E M ™
The Professional Temperature Manage-
ment System™ is located at the top of
the fresh food compartment.
NOTE:
Allow the refrigerator to run for 8-12
hours before loading. This ensures
appropriate temperatures for food
storage.
P S
OWER WITCH
Touch this pad to start or
stop cooling and turn off the
lights in both the fresh food
and freezer compartments.
This pad DOES NOT shut
off power to the refrigerator.
To turn off all power to the refrigerator,
turn the Main Power switch OFF or "O"
(see page 4).
IMPORTANT:
Turn off all power to the refrigerator at
the main power switch whenever
changing light bulbs, cleaning or serv-
icing this refrigerator.
I T
NITIAL EMPERATURE
S
ETTINGS
Temperatures are preset at 37° F (3° C) in
the fresh food compartment and 0° (-18° C)
in the freezer compartment. The display
will show the average compartment tem-
peratures, based on several measurement
points within the compartment.
NOTE:
Temperatures displayed may vary from
set point due to door openings or
during defrost.
NOTE:
Thermometers placed in the refriger-
ator may record a temperature slightly
above or below the displayed tempera-
ture. This is normal as the displayed
temperature is an average.
T
EMPERATURE
A
DJUSTMENTS
• Allow the temperature to stabilize for
24 hours after loading the refrigerator
before making any temperature adjust-
ments.
• The first touch of the up or down
arrow shows the current temperature
setpoint.
• Subsequent touches of the
raise the temperature set point or
the pad lowers the temperature set
point.
• The display will show the new setpoint
for approximately three seconds, then
return to the actual temperature
currently within that compartment.
• Limit temperature changes to one
degree at a time. Allow the new tem-
peratures to stabilize for 24 hours
before making a new temperature
adjustment.
D A
OOR LARM
The Door Alarm will alert you
when one of the doors has
been left open for 10 contin-
uous minutes. When this hap-
pens, the compartment light
will go out and a chime will sound every
few seconds until the door is closed or
the Door Alarm pad is pressed to deacti-
vate the function.
• Press the Door Alarm pad to activate.
A chime will sound and ON will illumi-
nate.
5
• Press the Door Alarm pad again to
deactivate.
• When the alarm has sounded, close
door to reset.
OR
• Press the Door Alarm pad to deacti-
vate. Press again to reactivate, if
desired.
W F
ATER ILTER
• WORKING is illu-
minated when a
water filter has been
installed. It will not
illuminate when the
filter bypass is in
place (see page 13
for information on installation of the
pad water filter or bypass).
• ORDER will illuminate when 90 per-
cent of the volume of water for which
the filter is rated has passed through
the filter.
OR
Eleven months have elapsed since the
filter has been installed.
• REPLACE illuminates when the rated
volume of water has passed through the
filter or 12 months have elapsed since
the filter was installed. A new filter
should be installed immediately when
REPLACE is illuminated.
When the new filter is installed, the
WORKING light will reluminate. See
page 13.
NOTE:
Power to the refrigerator must be ON
when the filter is changed for the
water filter monitoring system to reset
and change back to the "WORKING"
indicator.