After Using Your Appliance; Working With The Blender; Adding More Ingredients - SilverCrest SKM 550 B1 Mode D'emploi

After using your appliance

1) Switch the appliance off using the rotary
switch .
2) Turn the continuous shredder
and remove it.
3) Disassemble the continuous shredder
clean all parts as shown in the section "Clean-
ing and care".

Working with the blender

WARNING! RISK OF INJURY!
► Allow hot fluids to cool to a lukewarm tem-
perature (approx. 30 - 40°C) before pouring
them into the blender
WARNING! RISK OF INJURY FROM
SHARP KNIFE/ROTATING DRIVE!
► Never put your hand into the attached
blender while it is running!
► Remove the blade from the blender
when it is at a complete standstill.
► Only use the blender
position.
► In cases of malfunction, switch the appliance
off and remove the plug from the wall socket.
This will prevent the appliance from becoming
switched on again unintentionally.
Proceed as follows to prepare the appliance for
operation using the blender
1) Press down the release button
the pivot arm into operating position 3
(see the section "Operating positions").
SKM 550 B1
anti-clockwise
and
.
only
with the lid firmly in
:
and move
2) Remove the protective cover for the blender
drive hub (turn so that the marking "
the protective cover for the blender drive hub is
in line with the marking " " on the appliance
itself) (Image F).
3) Position the blender
(so that the marking "
lines up with the marking " " on the appli-
ance).
Turn the blender anti-clockwise until the stop
(so that the marking "
lines up with the marking " " on the appli-
ance itself) (Image G).
4) Add the ingredients.
–
Maximum fill quantity: approx. 1 litre;
–
Foaming liquids, maximum 0.5 litre;
–
Ideal processing quantity for solids: 50 - 100 g.
NOTE
► Take note of the table in the section
"Recommended filling quantities".
5) Place the lid onto the measuring jug slightly
offset and then turn it until the lid clicks into
place (Image I).
6) Turn the rotary switch

Adding more ingredients

1) Switch the appliance off using the rotary switch
2) Rotate the lid of the blender
remove the lid and add the ingredients you
want to mix
or
3) Rotate the measuring jug, which is placed in
the lid of the blender
Then gradually add the solid ingredients
using the opening provided for this purpose.
" on
on top of the appliance
" on the blender
" on the blender
to the required setting.
a little (Image I),
, by 90° and remove it.
GB │ IE │
23 ■
.