Before Use; Safety Instructions - JB Systems Light LED STRIP Mode D'emploi

ENGLISH
Thank you for buying this JB Systems product. To take full advantage of all possibilities and for your own
safety, please read these operating instructions very carefully before you start using this unit.
FEATURES
This unit is radio-interference suppressed. This product meets the requirements of the current European and
national guidelines. Conformity has been established and the relevant statements and documents have been
deposited by the manufacturer.
• This device has been designed to produce decorative effect lighting and is used in light show systems.
• Multicolor plastic tubes with RGB LEDs inside, used to change the color of walls, ceilings, etc. in all kinds
of venues: bars, discotheques, taverns, shops, ...
• Infinite applications possible: fix the strips behind translucent plexi panels to create slowly changing
colored surfaces, ceilings and walls...
• Mounting clips and screws included.
• Solid 4pin connectors with security lock.
• To be used with our LED-MANAGER (dmx power supply)
• Longlife LED Technology!

BEFORE USE

• Before you start using this unit, please check if there's no transportation damage. Should there be any, do
not use the device and consult your dealer first.
• Important: This device left our factory in perfect condition and well packaged. It is absolutely necessary
for the user to strictly follow the safety instructions and warnings in this user manual. Any damage caused
by mishandling is not subject to warranty. The dealer will not accept responsibility for any resulting defects
or problems caused by disregarding this user manual.
• Keep this booklet in a safe place for future consultation. If you sell the fixture, be sure to add this user
manual.
Check the contents:
Check that the carton contains the following items:
• Operating instructions
• LED STRIP
• 2 Plastic mounting clips + screws
JB SYSTEMS®
OPERATION MANUAL
1/20 LED STRIP
ENGLISH

SAFETY INSTRUCTIONS:

• To protect the environment, please try to recycle the packing material as much as possible.
• Do not expose this appliance to rain or moisture.
• To avoid condensation to be formed inside, allow the unit to adapt to the surrounding temperatures when
bringing it into a warm room after transport. Condense sometimes prevents the unit from working at full
performance or may even cause damages.
• This unit is for indoor use only.
• Don't place metal objects or spill liquid inside the unit. If a foreign object enters the unit, immediately
disconnect the installation setup from the mains power.
• Prevent use in dusty environments and clean the unit regularly.
• Keep the unit away from children.
• Inexperienced persons should not operate this device.
• Maximum save ambient temperature is 45°C. Don't use this unit at higher ambient temperatures.
• Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
• The electrical installation should be carried out by qualified personal only, according to the regulations for
electrical and mechanical safety in your country.
• The cables should always be in perfect condition: switch the LED Manager immediately off when the
cables are squashed or damaged.
• This appliance must be used with the LED Manager: don't connect the unit to any dimmer pack or other
power supply.
• In the event of serious operating problems, stop using the fixture and contact your dealer immediately.
• The housing must be replaced if it is visibly damaged.
• Please use the original packing when the device is to be transported.
• Due to safety reasons it is prohibited to make unauthorized modifications to the unit.
Important: Don't use the effect in the presence of persons suffering from epilepsy.
DESCRIPTION:
1. LED Strip enclosure with high intensity LEDs inside.
2. Plastic mounting clips, including screws.
3. Special female 4-pin connector: output to the next unit.
4. Special male 4-pin connector: input from the previous unit.
JB SYSTEMS®
OPERATION MANUAL
2/20 LED STRIP