Use Of The Machine; Changing The Default Settings - REVER 9340 N Notice D'utilisation Et Entretien

Line SALVASPESA
LED displaying vacuum level.
Welding bar cm. 32 (for bags cm.30).
Continuous duty.
Power cord storing compartment.
Air intake for container coupling.
Max. absorbed power: 180W
Max. vacuum level: -850 mbar
Aspiration capacity: 18 lt/min
Included in the package:
20 bags cm. 20x30 (6722 A)
COMPONENTS
1. Air pump on/off switch
2. Welding switch
3. Yellow led – pump operation
4. Green led – vacuum
5. Red led – vacuum level
6. Cover
7. Cover opening valve
8. Vacuum chamber
Cod. 9340 N - 9340 NAUS - 9340 NCSA - 9342 N (S-T-R-B) - 9346 N (F) - 9348 N (F) -
9344 N

USE OF THE MACHINE

Introduce the supply cable plug into a socket with suitable voltage. The unit is ready for
operation.
Press switch (1.) to start the air pump and air suction. Press the switch again to stop the
unit. When the air pump is working, press switch (2.) to operate the welding bar until the
automatic relay switch on. The unit stops automatically after a pre-determined time or by
pressing the on/off switch.
The green LED (4) also acts as welding time meter: during welding it flashes as many
times as the number of time/power units set.
The red LED lights up when a sufficient vacuum level has been achieved. Nevertheless
welding can be postponed to reach a higher vacuum level; this operation does not cause
any damage to the unit.

CHANGING THE DEFAULT SETTINGS

SEAL POWER SETTING
1- With the appliance connected to the power supply
2- Push 10 times in 10 seconds the seal switch (2), green led ( if present ) will light on fast to
indicate you are entered in setting mode
3- If green led do not light fast, re-start from point 1
4- Push the pump switch (1) once per each unit of time/power you need ( default set is 5 units),
green led ( if present) will light once per each time you push
9. Welding bar
10. Air suction
plug
11. Slide
98