REVER 9340 N Notice D'utilisation Et Entretien page 97

1) Prepare the food which is to be vacuum preserved taking off every thorns or spikes could pierce the
bag, in an embossed bag of adequate size, leaving about 5 cm from the edge of the bag and the
food.
2) Lift the cover up .
3) Place the open side of vacuum bag in the vacuum chamber, between the gaskets. Image 1
4) Close the cover and press pump switch ( 1 ). This will start vacuum operation.
5) As soon as vacuum pump starting, slightly press with both hands the cover so as it sticks to the
surface of the bag. After a few seconds the depression created by the pump will permit to release the
cover, while the machine will keep on suction.
6) The indicator on red shows that the right vacuum level is reached.
7) Press welding switch (2) to start welding operation, the machine will automatically stop at the end of
the cycle.
USER INTERVENTION
Every operation will stop when pressing pump switch ( 1 ).
It is possible to start sealing cycle when a correct vacuum level is attended ( between the two black
lines on green space of the manometer), the pump could have a loss of power in vacuum, it is normal.
If a correct vacuum level is not attended, the seal will not be good as a good seal will attended only if
the cover press in the right way the sealing bar.
VACUUM PACKAGING IN ROLLS
Lift the cover and place the roll (in well spread conditions) on the welding bar. Make sure that the
open side of the roll is NOT inserted in the vacuum chamber. ( Image 2 )
Start the air pump by pressing switch (1.). Slightly press your hands on the cover to produce an initial
depression in the vacuum chamber.
When the vacuum level is reached, the welding start automatically .
After welding the unit stops. Cut the roll and use like a bag.
To have a good first seal of the roll, use always automatic cycle.
VACUUM PACKAGING IN CONTAINER
(containers provided with vacuum valve are required for this operation; only containers suitable for
vacuum packaging, in plastic material or toughened glass, shall be used).
- Set on Manual cycle
- Lift the cover.
- Introduce the adapter hose into the air suction plugs.
- Fill the container leaving at least 3 cm. free room from the upper rim and place the cover on it.
- Slightly unscrew the cover cap so as to unlock the valve (attention: the cap must not be unscrewed
completely, some turns are enough).
- Place the adapter for containers on the cap.
- Start up the air pump by pressing switch until the desired vacuum level is reached.
- Stop machine, remove the adapter for containers from the container cover and screw the cap until
the valve is locked.
- To open the container, slightly unscrew the cap to unlock the valve; then move the valve to let air
into the container.
VACUUM PACKAGING WITH REBER UNIVERSAL COVERS
(REBER universal covers are available in different sizes to be suitable for containers, jars, bowls, pots
and pans of common domestic use, with diameters from 4 to 22 cm.)
- Operate as described for vacuum packaging in container, making sure that the container edge
perfectly adheres to the universal cover gasket.
- In case of prolonged use on the same container, the cover gasket may show a groove caused by
container edge. To avoid any problems, turn the gasket upside down: the groove will disappear in a
short time.
- The gasket can be removed to washing purposes. After drying, place it correctly in its seat;gasket
can be washed only by hand, never in dishwasher.
97