Installation Of The "Unibox Tq Vario - oventrop Unibox TQ vario Notice D'utilisation

Installation
1
2
3
4
5
6
7
Illust. 5: Installation cross section
(1) Block or stud wall
(2) "Unibox TQ vario"
(3) Plaster
(4) Pipe conduit unit (separate accessory)
(5)
Edge insulating strip (separate acces-
sory)
(6) Screed
(7)
Protective tube (separate accessory)
6.2 Installation of the "Unibox TQ
vario"
Install the "Unibox TQ vario" so
that the heating fluid passes first
through the surface heating circuit
and then through the valve of the
"Unibox TQ vario".
24
5 4
Illust. 6: Connection (example: operation
with control piston)
(1) Flow distributor/return collector
(2) "Unibox TQ vario"
(3) Surface heating circuit
(4) Supply
(5) Return
1. Provide a connection at the flow distributor.
2. Lay the surface heating circuit.
Lay the heating circuit in a spiral
pattern to achieve an even heat
distribution.
3. Remove the protection cover of the "Uni-
box TQ vario" (you must refit the protection
cover after commissioning) and place
the "Unibox TQ vario" into the wall at the
desired location.
Use a pipe conduit unit to facilitate
installation.
4. Use the enclosed brackets (see 1.2 auf
Seite 19) to align and fix the "Unibox TQ
vario".
Unibox TQ vario
1
2
3
102272980-V01.02.2020