Hayward PHOENIX 2 Guide De L'utilisateur page 20

Wheel or Bearing Removal & Replacement
1
4
When the unit is reassembled turn the right front wheel (looking from behind) and make sure everything turns smoothly.
Skirt and Inlet Removal & Replacement
Inlet Sizes:
Small*
small pump/variable speed
low flow
1
Turn the unit upside down
and press with both fingers
on both sides of the inlet.
While pushing down pull
up on the inlet.
8
*Low flow applications may affect cleaners ability to climb walls.
5
L R
2
Remove the inlet.
2
6
Medium
average pump
normal flow
3
Once the inlet is removed you
can remove any debris that is
in the turbine chamber. You can
also remove and replace the
skirt/bracket assemblies. One
of the middle skirt/brackets can
be easily pulled out. Once one
assembly is out you can slide
the others out easily to replace.
3
Large
large pump
high flow
4
Once any debris has been
removed or the skirts have been
replaced replace the inlet. Note
it can only be inserted in one
direction and once it is in it
should clip on both sides. Note:
if it does not clip in then you
have it the wrong way around (it
is marked L and R).
CLICK
7