Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Troubleshooting
Cleaner doesn't move or moves too slow.
The right wheel will not turn when rotated by hand.
(looking from behind)
The right wheel skips teeth when rotated forward by hand.
(looking from behind)
The loops in the hoses won't come out.
The cleaner turns in circles, it wont go straight at all.
The cleaner does not clean the entire pool.
The cleaner climbs the wall too much or climbs out.
The cleaner won't climb the wall.
When the pump turns off the hoses pop out of the skimmer or
suction inlet.
Wheels are wobbly.
The cleaner falls on its side and takes too long to recover.
Turbine vanes /blades pop out of turbine.
; ALWAYS TURN OFF THE SYSTEM BEFORE PERFORMING ANY REPAIRS.
Problem
•
Check wheel RPM.
•
Obstruction in the cleaner itself. If there was an obstruction
make sure vanes are replaced correctly.
•
The pump may be turned off or on low speed.
•
The pump may not be primed. Check for leaks in the system
(symptoms--bubbles from the returns ?) Possible other prob-
lem or obstruction in the system. Pump impeller blocked?
Filter needs backwashing. Clean pump basket, skimmers.
•
Turbine vanes/blades in wrong direction and/or wrong side.
•
Problem or obstruction in the system.
•
Obstruction in the cleaner itself.
•
Low wheel RPM (insufficient flow).
•
Obstruction in the cleaner itself.
•
Wheel hub or right drive gear worn/damaged.
•
The hoses have been stored in a coiled position. Lay them
straight in the sunlight.
•
Clean swivel on cleaner head by running it under a tap.
•
Leaf canister it may be in wrong place or not floating.
•
Wheel hub and/or large drive gear and/or steering slide as-
sembly and/or right drive gear are worn or damaged.
•
The hose is too short.
•
The float(s) may be in the wrong position. Should be 50-60
cm from cleaner head.
•
The Hose Cone Swivel (on the turbine cover) may be dirty.
•
The return fittings may be pushing the cleaner hoses away.
Point them down.
•
The tire treads and skirts may be worn down.
•
Too much suction or flow.
•
You are not using the Bypass Valve (if hook up is in skimmer).
•
Too little suction or flow.
•
Float may be in the wrong position.
•
Make sure hose cone is properly placed into inlet/port/water
gate.
•
Air in system. When pump shuts off air goes path of least
resistance and pops out the hose. Fix air leak.
•
Bearings are worn please replace.
•
The float(s) may be in the wrong position or missing.
•
The hose is too short.
•
The return fittings may be pushing the cleaner hoses away.
•
Check wheel RPM.
•
Wrong side of vane in the turbine hub. Large oval side should
be in turbine.
•
Turbine hub possibly worn.
Solution
9
Publicité
Table des Matières
