Hayward PHOENIX 2 Guide De L'utilisateur page 17

STEP 4
; submerging the cleaner.
Lower the cleaner into the water. While your pump is running,
take the end of the hose with the Adjustable Regulator Valve
(if you need it) and hold it against one of the return fittings to
expunge all of the air in the hose and the cleaner.
With the pump turned off, lower the cleaner and then vertically
push the hose down into the water until the hose is completely
filled with water.
YOU DO NOT WANT ANY AIR TO REMAIN IN THE HOSE AND THE
CLEANER!!
STEP 5
; connecting to suction.
1. Make sure that the filtration pump is turned OFF. SUCTION
CAN BE VERY DANGEROUS!!!
2. If you are hooking into a skimmer tightly press the Regulator
Valve and the Hose Cone (Valve Adapter) end into the bottom
of your skimmer. (see image
3. If you are hooking into a designated threaded suction
port/line then screw in the Vac Lock and insert the
Regulator Valve. (see image
OR
Insert the hose directly into the Vac Lock and use your 3-way
or ball valve to get the correct performance when the Regulator
Valve is not used. (see image
4. Switch the pump power back ON.
OR
)
A
)
)
A
5
5