Troubleshooting; Technical Data - Cleanmaxx JC-232 Mode D'emploi

Care
To ensure that the steam cleaner can clean with full force, the water reservoir (9) should
be descaled at regular intervals (after approx. 25 – 50 uses).
1. Pour a mixture of one part vinegar and two parts water into the water reservoir (9).
2. Position the device in such a way that the steam that is emitted does not hit any deli-
cate fl oors or other objects.
3. Insert the mains plug into a properly installed plug socket that is easily accessible.
4. Move the On / Off switch (7) to position I to switch on the device.
5. Allow the vinegar/water mixture to run through once completely until the water res-
ervoir (9) is empty.
6. Move the On / Off switch (7) to position 0 to switch off the device and pull the mains
plug out of the plug socket.
7. Rinse the water reservoir (9) with fresh water to remove vinegar residues and odours.

Troubleshooting

If the device does not work properly, fi rst check whether you are able to rectify the prob-
lem yourself.
Do not attempt to repair a defective electrical device yourself!
The device does not work. No steam is emerging.
• Is the mains plug inserted in the socket correctly?
• Is the socket defective? Try another socket.
• Check the fuse of the mains connection.
• Is the device switched on? Move the On / Off switch (7) to the I position.
• The device is not yet ready to operate. The device needs to heat up for around 20 –
30 seconds before the steam can emerge.
• The water reservoir (9) is empty. Top up the water reservoir (9) again (see "Filling
the Water Reservoir").
• Is the device scale-encrusted? Descale the water reservoir in the manner described
in "Cleaning and Care", in the "Care" section.

Technical Data

Model number:
Article number:
Power supply:
Protection class / rating:
19
JC-232
01784
220 – 240 V ~ 50 Hz, 1000 W
I, IPX4
EN