Maintenance And Service; Disposal Information - WOLFF ROBO-STRIPPER Traduction Du Mode D'emploi Original

6.0 Maintenance and Service

Maintenance and Cleaning
► Before any work on the machine itself, pull
the mains plug.
► For safe and proper working, always keep
the machine and ventilation slots clean.
The machine must then be sent to an after-sales
Service agent. Addresses are listed in the Section
"After- sales service and customer assistance".
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
Centre for WOLFF power tools.
In all correspondence and spare parts orders, please
always include the 10-digit article number specified
on the type plate of the machine.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
7.0 Troubleshooting
Fault
The machine does
not start
Higher exertion of force
required while working
Impact stop out after a
certain time

8.0 Disposal information

Disposal
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries
Do not dispose of power tools
into household waste!
According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national right, power
tools that are no longer usable must be collected separately
and disposed of in an environmentally correct manner.
Subject to change without notice.
www.wolff-tools.de
Possible cause Remedy
Power supply interrupted Contact
Defective fuse Electrician
Defective cable For repair and
Defective plug /or replace parts
Replace
Cutting blade dull cutting blade
or resharpen
Overload: temperature Cool down
protection switches off machine
:
26