Control Panel - WOLFF ROBO-STRIPPER Traduction Du Mode D'emploi Original

4.4 Control panel

► The machine is switched on and off with the main
switches (28, 29)
► The stroke mechanism is actuated by turning the
switch (30).
The impact is raised or lowered.
► The power supply is immediately disconnected
using the EMERGENCY stop (31).
► The impact is switched on/off for work using the
buttons 32 and 33.
► The joysticks on the right (36) and left (37) control
the two drive motors
5.0 Notes on various floor coverings
Operating instructions
► Do not place the power tool until a load that
causes it to stop.
The ROBO STRIPPER is primarily used to
remove linoleum, PVC, rubber, cork, design, and
CV coverings as well as needle-punched floor
covering and carpeted flooring.
Hardwood parquet, multi-layer parquet and
semiflexible tiles can also be removed to a
limited extent.
► Needle-punched floor covering, carpet, PVCP..
The coverings to be removed should be pre-cut in
blade-widths (fig. E) and then removed with the
stripper in one step. In many cases, the glue can
also be removed at the same time.
► Coverings without a foam backing:
Prior to performing the stripping work, pre-cut the
strips in blade-widths (fig. E). Regularly check
whether the blade is still straight and sharp.
Wolff GmbH & Co KG | D-74360 Ilsfeld | Ungerhalde 1 | Fon: +49 (0)7062-91556-0 | Fax: +49 (0)7062-91556-41 |
► Coverings with a foam backing:
Only use sharp blades! Remove the large sections
of the wearing surface. Use a carpet pulling claw for
this.
Then remove the foam residue with the stripper. If
there is some foam in the recess, approach from
the side.
► Coverings with a fleece backing:
Do not remove the wearing surface beforehand. Cut
the covering into strips and strip them together with
the fleece backing.
► Semi-flexible tiles:
Provided they are not extremely flexible, semi-
flexible tiles can be removed without pre-cutting
them.
► Parquet
Prior to performing the stripping work in bladewidths,
saw the parquet parallel to the installation
direction. Depending on the glue, it may need to be
sawed several times.
Important blade recommendation:
In general, no statements can be made on which
blades can be used for which blades, because
the variety of coverings and surfaces are too
diverse. These recommendations are to provide
assistance!
► With U-blades, the pre-cutting step in not necessary
for many flexible coverings, the coverings must be
checked on-site.If the tyre wear is highly visible on
the surface, the U-blade should not be used.
► We recommend using flat blades of varying lengths
and widths for flexible, elastic floor coverings. The
harder the covering, the thicker the blade should be.
► The blade is generally inserted with the blade edge
up, unless it works itself too deep in the surface. In
this case, the blade must be inserted with the blade
edge down.
► The heavy-duty special blades are generally suitable
for hard coverings, such as parquet.
www.wolff-tools.de
25