EUROM CK501H Manuel D'utilisation page 11

20. Close supervision is necessary when the product is used near children or incapacitated persons. Do not let
children use the appliance as a toy. This appliance is not suitable to be operated by children or persons who
have physical, sensory and/or mental limitations, or by persons who have no knowledge of, or experience
with, this appliance.
21. Keep the heater clean. Dust, dirt and/or a build up of deposits in the heater are a common cause of
overheating. Make sure these deposits are removed regularly.
22. Do not turn on the appliance if you have discovered damage to the heater itself, the cord or the plug, if the
appliance is malfunctioning, if it has been dropped or if there are any other signs of a defect. Return the
complete product to the vendor or to a certified electrician for inspection and/or repair. Always ask for original
parts.
23. Do not use attachments and/or accessories that have not been recommended or supplied by the
manufacturer.
24. The appliance (incl. cord and plug) may only be opened and/or repaired by properly authorised and qualified
persons.
25. Only use this heater for its intended purpose and as described in this instruction manual.
Not abiding by instructions 23, 24 and 25 may lead to damage, fire and/or personal injuries. A failure to ahdere to
these rules also immediately nullifies the guarantee and the vendor, importer and/or manufacturer take no
responsibility for any of the consequences!
Description
Location and Connection

Remove all packaging material and keep out of reach of children. After removing packaging, check the
appliance for damage or other signs that could indicate a fault/defect/malfunction. In case of doubt, do not
use the appliance, but contact your vendor for inspection or replacement.

Choose a suitable location for the heater, i.e. at least one metre away from any obstructions, walls or
inflammable materials (see also safety instructions).

The heater needs to be mounted on the wall. Make sure the wall is solid, totally vertical and non-flammable.
Do not use wooden or synthetic walls! The distance between the bottom of the heater and the floor should
be at least 20 cm. The distance between the heater and the sidewalls should be at least 30 cm and the
distance between heater and ceiling at least 50 cm. Do not mount the appliance directly below or in front of
a socket.
bracket. Make sure the heater and bracket are securely attached and that the heater is
completely horizontal.
The CK501H frost shield is an electrical convector heater with
a thermostat and an overheating safeguard. The light is
illuminated when the frost shield is switched on. The CK501H
frost shield is intended to keep small domestic or similar
spaces frost-free. The heater may only be used when
mounted on the wall (never if it is standing up or lying down!)
and only for the purpose for which it was designed.
1 = air outlet grill
2 = pilot lamp
3 = thermostat dial
4 = air inlet grills

Loosen both screws on the
suspension bracket and fix the
assembly bracket horizontally to
the wall, using the screws
provided. Slide the heater back
over the bracket and secure
both screws at the side of the
11