Classification Of Press Devices; Interchangeable Jaw; Initial Use; Performing The Pressing Operation - NovoPress AFP101 Manuel D'utilisation

3

Classification of press devices

Device type 1
AFP101
ACO102
ACO103
4

Interchangeable jaw

Caution!
Risk of injury from inadvertent pressing of the start button when
installing the segments in the interchangeable jaw.
Therefore:
–
Installing the segments in the interchangeable jaw (Fig. 1)
Push the segments into the interchangeable jaw as shown (Fig. 1) until they engage.
Removing the segments from the interchangeable jaw
Press the button (A/Fig. 1) while simultaneously pushing out the segment.
5

Initial use

Note!
When inserting the interchangeable jaw/adaptor jaw in the press device compliance
with the Operating Manual of the press device is mandatory.
Insert the interchangeable jaw/adaptor jaw in the press device.
6

Performing the pressing operation

WARNING!
Risk of injury from ejected fragments as the result of material fatigue.
Press tools are wearing parts. Frequent pressing will result in material fatigue. Press
tools worn or damaged in any other way as the result of material fatigue can break
even if used properly; there is then a risk of injury from ejected fragments. The risk of
breakage is further increased in the event of improper use.
Device type 2
EFP1 / EFP2
ECO1 / ACO1
ECO201 / ACO201
EFP201 / AFP201
EFP201plus
EFP202 / AFP202
ECO202 / ACO202
ECO 203 / ACO203
HFP1 / HFP2
MFP2
PFP2
Only install segments in the interchangeable jaw when the interchangeable jaw is
not mounted onto the press device.
Device type 2XL Device type 3
ACO202XL
ACO203XL
ECO301
11
Press tools
EFP3
AFP3
ECO3
ACO3
EN