Problem Identification - Miogarden Premium ARM 4680 Li Manuel D'utilisation

14. PROBLEM IDENTIFICATION

PROBLEM
1. The motor does
not start when the
switch is pressed
2. The motor shuts
down whilst working
3. The motor stops while
working and the machine
alarm buzzer is triggered
4. The motor is running
but the cutting means
is stationary
5. The cut grass is
not collected in the
grass catcher
6. Mowing is diicult
7. Excessive noise and/or
vibration is experienced
whilst working
PROBABLE CAUSE
Safety key is not inserted or is inserted
incorrectly
Battery is not inserted or is
inserted incorrectly
Low battery
Motor start-up is slow
The thermal protection has tripped
due to overheating of the motor
Battery is not inserted correctly
Low battery
Obstructions that prevent
rotation of the cutting means
The thermal protection has tripped
due to overheating of the motor
Thermal protection has tripped due to
excessive current absorption caused by:
• excessively high grass cutting
• obstructions that prevent
rotation of the cutting means
• too much grass debris accumulated in
the chassis and discharge channel
The cutting means ittings are loose
The cutting means has collided with a
foreign object and received a knock
The inside of the chassis is dirty
The cutting means is not
in good condition
Cutting means ittings are loose or
the cutting means is damaged
Insert the key (par. 6.3)
Open the hatch and check that the battery is
itted into its housing correctly (par. 7.2.4)
Check the battery status and
recharge. (par. 7.2.3)
Press and hold the control lever
for 1-3 seconds (par. 5.2)
Wait for at least 5 minutes and then restart
the machine
Open the hatch and check that the battery is
itted into its housing correctly (par. 7.2.4)
Check the battery status and
recharge. (par. 7.2.3)
Remove the safety key, put on your work
gloves and remove any grass remains
or debris from the lower part of the
machine and/or the discharge channel
Wait for at least 5 minutes and then restart
the machine
• Set a higher cutting height when the
grass is very tall, then set a lower height
and cut the lawn again (par. 7.2.1)
• Remove the obstructions (par. 7.3.2)
• Clean the machine (par. 7.3.1)
Wait for at least 5 minutes and then restart
the machine
Immediately turn of the motor
and remove the safety key.
Contact an authorised Technical Assistance
Centre for correct fastening support (par. 8.1)
Turn of the motor
Inspect for damage and
Contact a Technical Assistance Centre
for the replacement of the cutting
means if necessary. (par. 8.1)
Clean the inside of the chassis to
ease the grass discharge towards
the grass catcher (par. 7.3.2)
Contact a Technical Assistance
Centre for the sharpening or
replacement of the cutting means
Immediately turn of the motor
and remove the safety key.
Contact an authorised Technical
Assistance Centre for checks,
replacements or repairs (par. 8.2)
EN - 12
REMEDY
and remove the safety key.