Whirlpool UVL5430JSS Instructions D'installation Et Guide D'utilisation Et D'entretien page 9

Transfer measurement A to the cabinet back wall. Measure
from the underside of the cabinet. Mark the cutout as shown.
Use a saber saw or keyhole saw to cut a round opening
through the back of the cabinet and the exterior wall for
Go to Step 3.
A
B
A. Measurement A
B. Centerline
C. 6 / " (15.9 cm) round cutout
1
4
Non-Vented (recirculating) Installation Through
the Soffit/Cabinet
Measure and mark the centerline of the cabinet to the
Measure from the bottom of the cabinet to the centerline of
location and use a saber saw or keyhole saw to cut a 5
(14.6 cm) hole for the vent cover.
A. Vent cover
B. Centerline
C
A
B
Measure and mark the centerline location for the cutout in
the cabinet top. Use a saber saw or keyhole saw to cut an
opening for the vent.
A. Cutout
B. *See chart below.
C. 7
D. Centerline
Cabinet Height
12" (30.5 cm)
/ "
3
4
15" (38.1 cm) cabinet
18" (45.7 cm) or
For non-vented (recirculating) installations only, the range
hood can be vented indoors through the top of the cabinet.
are necessary. See the "Range Hood Care" section for
Recirculation Kit. See the "Assistance or Service" section
to order.
A
B*
D
/ " (19.7 cm) centerline to cabinet front
3
4
Hole Shape and Size
A 6 / " deep x 8" wide (15.9 cm x
1
4
20.3 cm) rectangular opening in the
cabinet top is required for damper
transition clearance.
A 6 / " (15.9 cm) diameter
1
4
A 5 / " (14.6 cm) diameter round
3
4
opening is required.
C
9