Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Non-Vented (recirculating) Installation through the
Cabinet/Soffit
Through top of Cabinet:
Recirculating through
the cabinet top wall
A
G
D
F
I
E
H
A. Ceiling
B. Recirculating grid
C. Soffit
D. 6" (15.2 cm) round vent system
E. Range hood
Through Soffit:
Recirculating through
the soffit
A
B
G
F
D
E
A. Ceiling
B. Recirculating grid
C. Soffit
D. 6" (15.2 cm) round vent
system
1. Measure and mark the centerline of the cabinet to the soffit
above.
2. Measure from the bottom of the cabinet to the centerline of
the where the vent will come through the soffit or cabinet top
wall. Mark the location and use a saber saw or keyhole saw
to cut a 5¾" (14.6 cm) hole for the vent cover.
10
F. Cabinet
G. Wall
H. 12" (30.5 cm) minimum
cabinet height
I. 17" (43.2 cm) minimum vent
cover height
E. Range hood
F. Cabinet
G. Wall
A
A. Vent cover
B. Centerline
NOTE: For 12" (30.5 cm) high cabinets a 6¼" deep x 8" wide
(14.6 cm x 20.3 cm) rectangular opening in the cabinet top is
required for damper transition clearance.
3. Consider the cutout chart measures to make the openings
on the cabinet.
NOTE: 12" (30.5 cm) high cabinets without a soffit may allow the
6" (15.2 cm) vent and vent cover to be seen.
Complete Preparation
Installation brackets configuration
To assemble the installation brackets, you must consider
the cabinet's material thickness and your cabinet's width
(30" [76.2 cm] or 36" [91.44 cm]).
1. Measure your cabinet material thickness, then locate the
bracket's installation holes, based on your cabinet thickness
(see the chart below).
Cabinet
material
thickness
5
4
3
2
1
B
Bracket
Cabinet
marks
Thickness
1
3/8"
2
1/2"
3
5/8"
4
3/4"
5
1"
Publicité
Table des Matières
