Shut Down; Advanced Menu Controls - DeVilbiss Healthcare SleepCube DV54 AutoAdjust Guide D'instructions

aDVancED mEnu controlS

Press the delay button to activate the comfort delay feature. The airflow pressure will drop to
the prescribed comfort delay pressure.
In the final 10 minutes of the delay period, the pressure will gently rise to the pressure
prescribed for your therapy. You may repeat the comfort delay by pressing the delay button
again if you have not fallen asleep during the first use.
Comfort Delay Feature in AutoAdjust Mode
When you use the comfort delay feature while your SleepCube is operating in AutoAdjust
mode, the airflow you receive at the beginning of your therapy is the lowest pressure
prescribed by your physician when the device was setup.
You do not need to activate the comfort delay; it will turn on automatically. The airflow
pressure will rise only to the low pressure setting and remain there for the duration of the
delay period. The AutoAdjust will not adjust the pressure setting during the comfort delay
period, allowing you to fall asleep without responding to early respiratory events.

Shut Down

Press the ON/OFF button to turn the device off. You may also simply remove your mask.
After a few seconds the device will display the message "Mask Off. Please check mask fit." If
you do not put the mask on again the device will automatically turn off in about 20 seconds.
Pressing any button will remove the message from the display.
NOTE–
If the DeVilbiss SleepCube does not turn off automatically, the feature may have been disabled. In this
case you must manually turn the device off.
aDVanCeD menU ConTRols
With the device on, press the "Next" or "Previous" buttons on the keypad to scroll through
the items on the display. Not all of the features in the table below are available in all models;
some are optional and some depend on what your physician and/or home care provider has
selected. The table shows the items you may see, and describes the feature associated with
each item. Also, some features are only available in AutoAdjust Mode or with the DeVilbiss
SmartLink™ Therapy Management Module – these are noted in the 'Mode' column below. If
you do not see some of these options, your model or configuration does not support them.
Name
PREVIOUS ITEM
NEXT ITEM
SETTING CHANGE
Please note that the values displayed are examples only.
Symbol Function

Pressing this button displays the previous menu option.

Pressing this button displays the next menu option.

These buttons allow you to adjust the setting that is
shown on the display.

EN
SE-DV54
11