Installation; Working Position; Boiler Fixing - Riello RG2KD Manuel D'entretien

3.

INSTALLATION

THE BURNER MUST BE INSTALLED IN CONFORMITY WITH LEGISLATION AND LOCAL STANDARDS.
3.1

WORKING POSITION

The burner is designed to work only in the po-
sitions 1, 2, 4 and 6.
Any other position could compromise the cor-
rect working of the appliance.
Installations 3 and 5 are forbidden for safety
reasons.
3.2

BOILER FIXING

To fit the burner to the boiler it is necessary to carry out the following:

Put on the flange (1) the screw and two nuts, (see fig. 3).

Widen, if necessary, the insulating gasket holes (5), (see fig. 4).
 Fix the flange (1) to the boiler door (4) using screws (2) and (if necessary) the nuts (3) interposing the
insulating gasket (5), (see fig. 2).
Fig. 4
D5012
3023
1
4
Fig. 3
3 GB
2 3
5 6
Fig. 2
S7209
D4420