Reely Dart Notice D'emploi page 46

Setting Front Axle Camber:
For setting the camber, turn the screw (A) of the upper
transverse link.
A suitable open-faced spanner or flat pliers can be used for
turning (not enclosed).
Because this screw has a left and right hand thread at ei-
ther end, the transverse link does not need to be disman-
tled for the camber to be adjusted.
Setting Rear Axle Camber:
For setting the camber, twist the screw (A) of the upper
transverse link as for the front axle.
A suitable open-faced spanner or flat pliers can be used for
turning (not enclosed).
Because this screw has a left and right hand thread at ei-
ther end, the transverse link does not need to be disman-
tled for the camber to be adjusted.
Observe:
• Change the settings only gradually and then check the changed running conduct to see if it corresponds
to your expectations. Write down the changes made so that you can easily reverse them again.
• Twist the screws of the two transverse links at the front axle and the rear axle evenly at all times, since
different settings at the left/right wheel will cause unforeseeable driving behaviour.
46
A
A