Wetrok Turbo Sweep 770 Plus Manuel D'utilisation page 15

Table des Matières

Les langues disponibles

EXCHANGING BRUSHES

The TURBO SWEEP 770 machine brushes are made of highly wear-resistant material. After using them many years, it may be neccessary to replace

them. We recommend to replace the complete brush set at the same time. For the replacement of the circular brushes, set the height adjustment (item

1.11) to step 8 and place the machine vertically. Then, pull the oblique wheel (item 4L/R) strongly and remove it together with the shaft from the machi-

ne. Next, strongly pull off the circular brushes (item 2L/R) together with the tooth sleeve and the clutch (item 3L/R) from the pivot housing.

Attention: The markings for L and R are applied on the inside of the frame (item 1.12), on the helical gears and on the clutches (item 3.10). The circular

brushes are marked on the bottom with L/// or R\\\ depending on the direction of the bristles. Ensure that the correct side of assembly is used. The

assembly is carried out in reverse order: Fit the circular brushes into the pivot housing. Then, fit the clutch (item 3.10) into the tooth sleeve (item 3.02)

and insert them into the circular brush. Lastly, insert and engage the oblique wheel – and you're ready to go. For the replacement of the sweeping roll,

press the stop bracket of the brush holder (item 8.15). Ensure that the bristles are not pinched laterally and that the stop bracket is in its correct starting

position again.

GUARANTEE

4 year warranty against wear for the disc brushes

2 year warranty for all other parts referring to the EU-law

(excludes wear)

WHAT SHOULD BE DONE WHEN THE UNIT DOES NOT RUN SMOOTHLY?

1. Check the sweeping pressure adjustment

2. Clean the unit and remove spooled laces etc.

3. Check the sense of rotation of the circular brushes (after repair)

Deutsch

Français

Italiano