SOLIS 698 Mode D'emploi page 69

Step 2: Connecting WiFi router and heater (to connect, the smartphone and the
heater have to be logged on to the same WiFi network)
1. Check if the heater is connected to the power (connect power plug to wall
outlet) and switched on with the power tilt switch on the appliance backside,
so that it is in standby mode.
2. Open the app.
3. Switch the heater on with the ON / OFF button
on the appliance backside pressed until the
panel.
4. Then, click „Add a new device" in the app (fig. 1). The detected WiFi network
is displayed (fig. 2).
5. Enter the corresponding WiFi password of the router and then press the arrow
symbol (fig. 2). Wait approx. 120 seconds (you can watch the time being count­
ed down on your smartphone).
6. The user interface appears on your mobile phone. You can now comfortably
operate your ceramic heater with your smartphone (fig. 3)
fig. 1
TIP: You can rename the appliance by touching and holding the appliance name in
the menu shown in fig. 1.
CAUTION: To permanently operate the appliance with your smartphone, it
has to be connected to the power and the power switch on the appliance
backside has to be set to the position „I", so that your appliance is in stand-
by mode. This allows it to be switched on and be programmed at any time.
NOTE: If you want to connect to a new WiFi network, press the WiFi button on
the appliance back side of the heater until the
previously mentioned steps.
fig. 2
;
and keep the WiFi button
symbol flickers in the control
fig.3
symbol flickers and repeat all
69