SOLIS 698 Mode D'emploi page 66

NOTES:
• You can only set your desired temperature by pressing the
that „°C" lights up in the control panel and then using the
tons to set the temperature. Only pressing the
the or
last set temperature stays saved.
• If you have selected the automatic ECO mode, you can not set a desired tem­
perature. The standard setting in ECO mode is 22 °C and can not be changed.
In general:
• The built­in thermostat takes approx. 10 seconds to register the current room
temperature. As soon as it has registered the room temperature, the ceramic
heater starts up, provided the current room temperature is at least 2 °C lower
than the set temperature. If the current room temperature is at least 2 °C higher
than the set temperature, heating stops and the symbols for low or high heating
power in the control panel go out. When the temperature sinks again,
the appliance automatically switches back on.
• Please consider that the thermostat in the appliance can only measure the tem­
perature immediately surrounding the appliance. Should you simultaneously
measure the temperature with a thermometer some distance away from the
heater (f.e. in the other end of the room), the value measured by the thermome­
ter could be a few degrees lower than the value displayed by the heater. Should
the thermometer be positioned f.e. directly above the heater, the value could
be even higher than stated on the heater, as warm air rises up. The heating
function of the WiFi Ceramic Heater is determined by the temperature value
measured and displayed by the built­in thermostat of the heater.
• If you have set the timer, the set operation time and the current room temper­
ature alternately light up at 30 second intervals. If you have not set the timer,
the current room temperature is displayed constantly.
66
buttons afterwards will not set any temperature. Instead, the
button twice so
and
button twice without using
but­