Se Tt I Ng T He D Es Ire D T E Mp Erat Ure - SOLIS 698 Mode D'emploi

A D J US T I NG T IMER (O P ERA TI N G T IM E)
■ ■
1. You can adjust the timer and thus determine how long the appliance should
heat before automatically switching off with the MODE button
button once. The figure „0" flashes in the display next to „H",
2. Press the
representing hours. Press the
the button to decrease the number of hours. You can set any operating
time between 0 and 12 hours. Each press of the
change the setting by one hour. Keep the buttons pressed for 2 seconds or
longer and the display will quickly count up or down.
3. Not pressing either of the two buttons for 5 seconds or pressing any other but­
ton saves the setting. The display states the remaining operating time in hours
and the heater automatically switches to standby mode once it reaches „0"
NOTES:
• You can only adjust the timer by pressing the
lights up in the control panel and then using the
the time. Only pressing the
tons afterwards will not set an operating time and does not activate the timer.
• If you do not wish to set an operating time (setting „0" hours), your appliance
will stay active until it is manually switched off with the

SE TT I NG T HE D ES IRE D T E MP ERAT URE

■ ■
1. You can use the
button twice. The number flashes in the display, next to „°C"
2. Press the
representing degrees Celsius.
3. Press the button to increase temperature or the
temperature. You can set any room temperature you desire, between 5 °C
and 35 °C. Each press of the buttons
one degree. Keep the buttons pressed for longer than 2 seconds and the display
will quickly count up or down.
4. Not pressing either of the two buttons for 5 seconds or pressing any other
button saves the setting.
button to increase the number of hours or
button without using the
button to set the desired room temperature.
and
button once so that „H"
and buttons to set
or
;
button.
button to decrease
or changes the setting by
.
buttons will
but­
65