Table des Matières
Publicité
7
8
9
1
1
1
English
(1) Install the mounting nut, metal washer, and friction
washer on the diverter housing.
If the mounting surface is thin, install the spacers.
Otherwise, discard them.
Push the diverter housing up through the mounting
surface.
() Install the sealing gasket and spout base.
Rest the diverter housing on the mounting surface so
that the positioning pin goes into its hole.
(1) Tighten the mounting nut.
() Tighten the tensioning screws.
Install the connecting hoses on the valve outlets.
Publicité
Table des Matières
