stayer SC300W Instructions D'emploi page 43

7.List of contents
1.Provided uses of the machine.
2.Unpackaging and assembling.
3.Setting or fastening the machine in a stable
position.
4.Connection to the grid, wiring, fuses, socket
t y p e f o r t h e j a c k a n d g r o u n d i n g
conditions.
5.Illustrated descriptions of functions.
6 . L i m i t a t i o n s r e g a r d i n g e n v i r o n m e n t a l
conditions.
7.List of contents.
8.Settings and testing.
9.Changing tools.
10.Fixing for operation.
11.Limits regarding the workpiece size.
12.General instructions for use.
13.Precautions and working garment.
14.Special safety precautions.
15.Measures for preventing machine-specific
risks.
16.Dust extraction.
17.Protectors; safety and adjustment.
18.General safety instructions.
1 9 . R e g u l a r c l e a n i n g , m a i n t e n a n c e a n d
greasing.
20.Repair service by the manufacturer or
commercial agent.
21.List of parts that may be replaced by the user.
22.Special tools as possibly required.
23.Safe operation.
24.Technical specifications.
25.Warrantee.
26.Declaration of conformity.
8.Settings and testing
Warning!
Before any intervention on the electrical tool
remove jack from power socket.
If the machine has been subject to prolonged or
intense use, it must be checked and adjusted so as
to ensure the machine's correct quality of service
and safety.
ENGLISH
42
This requires knowledge, experience and special
tools. The official technical service of Stayer Iberica
S.A. will carry out that work for you in a quick
thorough and inexpensive manner.
Adjusting the locking in the lower resting
position
IMAGES
Information
One starts from the machine being locked in the
upper resting position.
1.Unlock by pressing button 4.
2.Lower down to the lower stop by means of 3.
3.Turn or pull knob 32. If the knob is well adjusted, it
must enter smoothly until abutting. Otherwise
proceed to adjusting.
4.Position protective guard 49 and turn disk 16 with
your hand. The disk must not strike against
t h e g u a r d 4 9 . O t h e r w i s e p r o c e e d t o
adjusting.
Adjusting
1.Loosen the fastening nut of screw 31.
2.Lower head to lower stop by means of 3.
3.Tighten or loosen screw 31 and rotate knob 32
clockwise until it smoothly penetrates to
abutment.
4.Once the stopper has been adjusted, tighten the
fasting nut of screw 31.
5.Proceed to check again
Adjusting the horizontal mitre angle to
- 45º
IMAGES
Checking
1.Loosen locking control element 13 by rotating it to
the left.
2.Pull control element 13 and move head
horizontally until indicator 36 marks +45º.
42
A B O
A E F
+