Status At Switching On - John Bean B 340 Manuel D'utilisation

6b
g
7b
52
inch
5-13
Operation

5.4.2 Status at switching on

The electronics is factory programmed so that upon
The electronic unit is factory-adjusted to the following
modes of operation, which are available after switching machine start-up the following operating modes are
on: pre-set:
– vehicle type 1 (car wheel with nominal
– vehicle type 1 (car wheel with nominal dimensions in
dimensions in inches, width 6.5" and diameter
inches, width 6.5" and diameter 15.0").
15.0")
– entry of rim data in inches.
– entry of rim data in inches
– display of amount of unbalance in 0,25 oz increments.
– display of amount of unbalance in 5 g increments
– suppression of minor unbalance readings (limit set
– suppression of minor unbalances (limit set to:
to 0,25 oz).
3.5 g)
– automatic braking of wheel when guard is opened
– automatic braking of wheel when guard is
during the measuring run.
opened during the measuring run
– compensation of adaptor unbalance switched off.
– compensation of adaptor unbalance switched
– Starting the mesuring run by closing the wheel guard.
off
- The measuring run is started by closing the
wheel guard.
5.4.3 Direct Settings
The unit of measurement indicated by default at power
up is inches, but the setting selected before switching
off in grams / ounces remains.
5.4.3.1 Dimension Unit Toggle
Default diameter and width unit setting: inches.
• Press the "mm" or "inch" icon (6b, Fig.5-13).
The measuring unit changes to the possible alternative.
5.4.3.2 Weight Unit Toggle
Default weight setting:
Select before or after performing a run, indifferently.
• Press the key "g" or "oz" icon (7b, Fig.5-13).
The measuring unit changes to the possible alternative.
ounces grams.