John Bean B 340 Manuel D'utilisation page 142

4
E
4
A
a
142
R
7-8
V W R
7-4
b
c
7-9
User Code
Setting the factory-adjusted modes of operation
( 6-2).
F
(Fig. 7-4) Select;
"SETTINGS"(4), "General Confi gurations"
—
(A), "Set the preset operating mode" (M),
No (*) = No action
Activate = Set default values
("Activate" status is only shown briefl y)
After the confi rmation, this operating mode can
be acquired in the permanent memory (Fig. 7-6).
Selecting the resolution of unbalance readings in
1 or 5 g, or 0.05 or 0.25 oz increments
(Fig. 7-5) Select;
— "SETTINGS"(4), "Operational Confi guration"(B),
"Unbalance resolution" (N),
Normal (*)= 5 g (0.25 oz) increments
Fine = 1 g (0.05 oz) increments
After the confi rmation, this operating mode can
be acquired in the permanent memory (Fig. 7-6).
Selecting suppression of minor unbalance
readings
(Fig. 7-5) Select;
— (4), (B), (O),
Disabled = Suppression off
Enabled(*) = Suppression on
After the confi rmation, this operating mode can
be acquired in the permanent memory (Fig. 7-6).
Wi-fi connections
(Fig. 7-3) Managing the network connections;
The machine can be connected to the network via Wi-fi .
The network connection lets the operator manage,
with a software (supplied separately), the printing from
remote and exchange the data between the balancer
and the workshop server (
Note: The selection can be acquired in the permanent
memory.
* = Factory confi guration
6.7).
F