John Bean B 340 Manuel D'utilisation page 134

4
A M
4
134
7-4
B N O
7-5
User Code
Setting the factory-adjusted modes of operation
( 5.4.2).
F
.
(Fig 7-4) Select;
"SETTINGS"(4), "General Confi gurations"
—
(A), "Set the preset operating mode" (M),
No (*)
= No action
Activate = Set default values
("Activate" status is only shown briefl y)
After the confi rmation, this operating mode can
be acquired in the permanent memory (Fig. 7-6).
Selecting the defi nition of the imbalance value in steps
Selecting the resolution of unbalance readings in
from 0.05 or 0.25 oz. (1 or 5 grams).
1 or 5 g, or 0.05 or 0.25 oz increments
.
7-5) Select;
(Fig
— "SETTINGS"(4), "Operational Confi guration"(B),
"Unbalance resolution" (N),
Normal (*) = 0,25 oz (5 grams) defi nition
Normal (*) = 5 g (0.25 oz) increments
Fine
= 0,05 oz (1 gram) defi nition
Fine = 1 g (0.05 oz) increments
After the confi rmation, this operating mode can
be acquired in the permanent memory (Fig. 7-6).
Selecting suppression of minor unbalance
readings
.
(Fig 7-5) Select;
— (4), (B), (O),
Disabled
= Suppression off
Enabled(*) = Suppression on
After the confi rmation, this operating mode can
be acquired in the permanent memory (Fig. 7-6).
* = Factory confi guration