medi circaid juxtafit essentials lower leg Mode D'emploi page 4

English
English
Step 7: Donning the circaid compression
anklet
First fold the bottom part of the circaid
undersleeve over the bottom edge of the
circaid garment. Slide the circaid
compression anklet onto the foot and
ensure that it is pulled high enough so
that it overlaps with the circaid juxtafit
garment. Ensure that there are no
wrinkles in the anklet.
Doffing the circaid® juxtafit®
essentials lower leg
To remove the garment, remove the
circaid compression anklet first. Then
unfold the circaid undersleeve. Detach
all bands of the legging starting with the
top band. Fold each band onto itself to
keep the Velcro tabs lint-free. Remove
the garment and then remove the
circaid undersleeve.
Recommendation for combination of
lower and upper leg with knee
garments:
If combining a circaid juxtafit essentials
lower leg with a circaid juxtafit
essentials upper leg with knee, ensure
that the upper leg with knee overlaps
with the lower leg.
Using the Built-In-Pressure card:
It is recommended to always use the
BPS card packaged with the product.
Step 1: Locate the Built-In-Pressure card
in your packaging.
Step 2: Starting with the bottom band,
line up the black triangle on the card
with one of the BPS lines on the bottom
band.
Step 3: Note where the second BPS line
lines up with the card´s compression
ranges.
Step 4: If the BPS line on the garment
either falls short (Fig. B) or goes beyond
the correct compression range (Fig. C),
readjust the band as necessary so that
the second BPS line on the garment is
aligned with the prescribed compression
range (Fig. A). Completely loosen the
band before reapplying it if too much
tension has been applied.
Step 5: Repeat the steps 2 - 4 for each
band going up the leg. Be sure to adjust
all bands to the same compression level.
Bands may need adjusting throughout
the day to maintain the prescribed
compression range.
A
B
✗
C
✗
✓