Spypoint BF-6 Manuel D'utilisation page 5

8
Test light
SET-TEST
Allows the user to test the detection system of the camera.
When the SET/TEST mode is selected, no picture or video is
recorded. Walk perpendicularly in front of the camera. When
the camera detects movement, the light blinks to indicate that
normally, a photo or video would be recorded. If the system does
not detect the movement, increase the distance detection using
the wheel DISTANCE or realign the system differently. When
you understand how the device responds to detections, you can
better adjust the direction or the height of the installation.
How to properly install your camera
using the supplied installation strap:
(Recommended installation height: about 3 feet).
VIEW
Allows the user to view photos and videos directly on a TV
set. Turn OFF the camera and select VIEW. Connect the yellow
end of the RCA cable (supplied) into the VIDEO IN of the TV
and the other end into the TV OUT of the camera. Turn ON the
camera and the last recorded picture or video will appear. To
change the picture or the video, use the key UP or DOWN. If
you press MENU/OK, the following options will appear:
9