Additional Precautions; Declaration Of Conformity - GYS GYSPOT PRO 400 Notice D'utilisation

SAFETY
Spot welding can be dangerous and can cause serious and even fatal injuries.
Protect yourself and others. Ensure the following safety precautions are taken:
Arc radiation
Rain, steam, damp
Electric shock
Falls
Burns
Fire risks
Fumes
Additional
Precautions
GYS cannot be held responsible for damage to persons or items, as a result of using the machine in the following
circumstances:
• Modification or neutralisation of safety elements has been undertaken
• Safety recommendations written in this manual have not been adhered to
• Modification of the product's specifications
• Use of accessories not specified by the manufacturer
• Failure to observe regulations specific to the country or state in which the machine is used.
People wearing pacemakers are advised to see their doctor before using this device.
Handle gas bottles with care - there is increased danger if the bottle or its valve are damaged.

DECLARATION OF CONFORMITY:

GYS Company attests under its own responsibility that products: GYSPOT 39.02, 39.04, Pro 230, Pro 400
and 2600 are manufactured according to the requirements of the following European directives:
Low voltage directive: 2006/95/CE – 12/12/2006
-
CEM directive : 2004/108/CE – 15/12/2004
-
They are in conformity with the harmonized standards:
EN 62135-1
-
EN 62135-2
-
EC marking date: March 2011
Le 01/03/2011
Société GYS
134 BD des Loges
53941 Saint Berthevin
8
Protect yourself with a helmet fitted with filters in compliance with EN169 or EN
379.
Use your welding unit in a clean/dry environment (pollution factor ≤ 3), on a flat
surface, and more than one meter from the welding work-piece. Do not use in rain
or snow.
This device must only be used with an earthed power supply. Do not touch the
parts under tension. Check that the power supply is suitable for this unit.
Do not move the unit over people or objects.
Wear protective (fire-proof) clothing (cotton, overalls or jeans).
Wear protective gloves and a fire-proof apron.
Ensure other people keep a safe distance from the work area and do not look
directly at the welding arc.
Protect others by installing fire-proof protection walls.
Remove all flammable products from the work area. Do not work in presence of
flammable gases.
Do not inhale welding gases and fumes. Use the device in a well ventilated
environment, with artificial extraction if welding indoors.
Any welding operation undertaken in:
- rooms where there is an increased risk of electric shocks,
- poorly ventilated rooms,
- the presence of flammable or explosive material,
Should always be approved by a "responsible expert", and made in presence of
people trained to intervene in case of emergency.
Technical protection as described in the Technical Specification CEI/IEC 62081 must
be implemented. Welding in raised positions is forbidden, except in case of safety
platforms use.
Do not use the welding unit to unfreeze pipes.
.
Nicolas BOUYGUES
Président Directeur Général/ CEO