Use Of The Appliance - Pelgrim GVW580ONY Notice D'utilisation

22
• To cancel a washing programme in pro-
gress. Refer to the chapter 'Setting and
starting a washing programme'.
Programme lights A and B
These lights have also an auxiliary function
when you:
• Adjust the level of the water softener.
• Deactivate/activate the audible signals.
Delay start button
Press this button to delay the start of the
washing programme of three hours. Refer
to 'Setting and starting a washing pro-
gramme'.
Setting mode
The appliance must be in setting mode
for these operations:
• To select and start a washing pro-
gramme.
• To adjust electronically the level of the
water softener.
• To deactivate/activate the audible sig-
nals.
Press the on/off button. The appliance
is in setting mode when:
• All the programme lights are off and the
end-of-programme indicator light flashes.
Press the on/off button. The appliance
is not in setting mode when:
• Only one programme light comes on.
– It is necessary to cancel the pro-
gramme to go back to the setting
mode. Refer to 'Setting and starting a
washing programme'.
Audible signals
You can hear the audible signals when:
• The washing programme ends.
• The appliance has a malfunction.
Do these steps to deactivate the
audible signals:
1. Switch on the appliance.

Use of the appliance

1. Be sure that the set level of the water
softener agrees with the water hard-
ness in your area. If not, adjust the wa-
ter softener.
2. Fill the salt container with dishwasher
salt.
2. Make sure that the appliance is in set-
ting mode.
3. Press and hold the programme button
until the programme light A flashes and
the programme light B comes on.
4. When the programme light A flashes
and the programme light B comes on,
press immediately the programme but-
ton again.
The programme light A comes on and
the programme light B starts to flash.
After some seconds the programme
light A goes off and the end-of-pro-
gramme indicator light comes on. (The
programme light B continues to flash).
– The audible signals are active.
5. Press the programme button again.
The end-of-programme indicator light
goes off.
– The audible signals are deactivated.
6. Switch of the appliance to confirm the
operation.
Do these steps to activate again the
audible signals:
1. Follow the procedure how to deactivate
the audible signals from point 1 to point
4.
2. The programme light A goes off. The
end-of-programme indicator light is off.
(The programme light B continues to
flash).
– The audible signals are deactivated.
3. Press the programme button again.
The end-of-programme indicator light
comes on.
– The audible signals are active.
4. Switch of the appliance to confirm the
operation.
3. Fill the rinse aid dispenser with rinse
aid.
4. Load cutlery and dishes into the appli-
ance.
5. Set the correct washing programme for
the type of load and soil.